Installing trim around closet doors

For an outside corner, gluing and nailing through the joint before nailing to the wall will provide the best long-term results. Painting crown molding on the wall is likely to leave you sore from raising your arms overhead for hours. Similarly, painting baseboards while resting your knees on the hard flooring is the pits.

Painting before installing trim can be a major energy and time saver, provided you have the space to do it. For the best results, purchase pre-primed boards whenever possible.

Lay trim boards across a pair of sawhorses. Use a brush, roller, sprayer, or some combination of all three to paint your boards before your trim installation begins. Do this for two to three coats to achieve a great finish. Apply a small amount of the filler with the tip of your finger and to each nail hole. Wait approximately two hours for the filler to cure before using a sheet of grit sandpaper to lightly sand away the excess material.

This will leave a smooth finish and make the holes disappear. Just touch it up with paint or stain, and your project is complete. Disclosure: BobVila. You agree that BobVila. All rights reserved. This is more than a stylistic detail.

The legs will expand and contract in width with seasonal humidity changes, and this will be noticeable if you install the head with its ends flush with the outside of the legs. So, the length of the head will be the jamb width, plus the reveals, the combined width of the legs, and whatever overhang you want on each side.

If you have a biscuit joiner or a pocket hole jig, the joints between the legs and the head on square casings are an excellent use for these tools. Otherwise, the nailing sequence is identical with square casings. Cookie banner We use cookies and other tracking technologies to improve your browsing experience on our site, show personalized content and targeted ads, analyze site traffic, and understand where our audiences come from.

By choosing I Accept , you consent to our use of cookies and other tracking technologies. How To Install Door Trim. By Andy Engel. Pinterest Email Pocket Flipboard. A miter joint is where the ends of two pieces of molding are cut at equal angles—45 degrees for a square corner. It also gives our wall color a proper stopping point. If you wish to have closets that are painted white, you either have to draw lines at the door, or install trim as described here.

This piece needs to be ripped on a table saw to match the width of the sheetrock from the corner to the top slider. If you do not have access to a table saw, you may find a close-enough width piece at your local hardware store. If your piece is too small however, you may need to move the location of the sliding rail to close any gaps between the trim and the door.