Ridgid microray manual

T rigger. I f the tr igger is pulled the unit will swit ch on. Ho w ev er , the back ligh t r emains. I f in S et mode , it ac c epts the par amet er change. F unc tion Butt on. I f in measur e mode , it c y cles thr ough the func tion loop. I f in S et mode , it incr eases the v alue.

Spec tr al band: mm. R epea tabilit y : 0. Displa y r esolution: 0. Emissivit y : pr e -set t o 0. Clean any oil, grease or dirt from equipment.

This aids inspec- tion. Inspect the micro IR for any broken, worn, missing, mis- Do not look into the laser beam. Looking into the laser beam aligned or binding parts, or any other condition which may pre- may be hazardous to the eyes. Page 9 The spot should always be smaller than the surface. The smaller 2. Inspect the object being measured to and confirm that you have the surface, the closer the micro IR should be to the sur- correct equipment for the application. See the Specifications face.

Keep away from any electrical, mov- ing or hot parts. Make sure that the unit is pointed in a safe di- Continuous Measurement Scanning Mode rection away from any bystanders before turning ON.

Page 11 Squeeze the trigger to exit the Settings mode and Backlight save your selection. Non-Contact Infrared Thermometer unsafe to operate. EC REV.

C All other trademarks belong to their respective holders. Vorherige Seite. This section is provided to improve understanding of these signal words and symbols. Keep proper footing and balance at all Read all safety warnings and in struc tions. Failure to follow the times. Make The micro IR uses optics to sense emitted, reflected and trans- sure the laser is aimed above or below eye level. Laser beams mitted energy, which is collected and focused onto a detector.

The may be hazardous to the eyes. Seite 7: Specifications Storage Temperature IP54 Weight Seite Pre-Operation Inspection 1. Clean any oil, grease or dirt from equipment. This aids inspec- tion. Inspect the micro IR for any broken, worn, missing, mis- Do not look into the laser beam. Looking into the laser beam aligned or binding parts, or any other condition which may pre- may be hazardous to the eyes.

Seite Set-Up The spot should always be smaller than the surface. The smaller 2. Inspect the object being measured to and confirm that you have the surface, the closer the micro IR should be to the sur- correct equipment for the application.

See the Specifications face.